P0605

P0605 ECM

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1.Turn ignition switch OFF and wait at least 10 seconds.
2.Turn ignition switch ON.
3.Turn ignition switch OFF and wait at least 10 seconds.
- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION A

1.Turn ignition switch ON.
2.Check 1st trip DTC.
Is 1st trip DTC detected?
YES- Proceed to .
NO- GO TO 3.

3. PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION B

1.Turn ignition switch ON and wait at least 1 second.
2.Turn ignition switch OFF, wait at least 10 seconds and then turn ON.
3.Check 1st trip DTC.
Is 1st trip DTC detected?
YES- Proceed to .
NO- GO TO 4.

4. PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION C

1.Turn ignition switch ON and wait at least 1 second.
2.Turn ignition switch OFF, wait at least 10 seconds and then turn ON.
3.Repeat step 2 for 32 times.
4.Check 1st trip DTC.
Is 1st trip DTC detected?
YES- Proceed to .
NO- INSPECTION END


Diagnosis Procedure


1. INSPECTION START

1.Turn ignition switch ON.
2.Erase DTC.
3.Perform DTC confirmation procedure. .
Is the 1st trip DTC P0605 displayed again?
YES- Replace ECM. Service and Repair.
NO- INSPECTION END