P0222

P0222, P0223 TP SENSOR

DTC Logic


DTC DETECTION LOGIC

NOTE:
If DTC P0222 or P0223 is displayed with DTC P0643 ,first perform the trouble diagnosis for DTC P0643.
P0340.






DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1.Turn ignition switch OFF and wait at least 10 seconds.
2.Turn ignition switch ON.
3.Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 8 V at idle.

- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE

1.Start engine and let it idle for 1 second.
2.Check DTC.
Is DTC detected?
YES- Proceed to .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK THROTTLE POSITION SENSOR 1 POWER SUPPLY

1.Turn ignition switch OFF.
2.Disconnect electric throttle control actuator harness connector.
3.Turn ignition switch ON.
4.Check the voltage between electric throttle control actuator harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- GO TO 2.

2. CHECK THROTTLE POSITION SENSOR 1 POWER SUPPLY CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect ECM harness connector.
3.Check the continuity between electric throttle control actuator harness connector and ECM harness connector.





4.Also check harness for short to ground.
Is the inspection result normal?
YES- Perform the trouble diagnosis for power supply circuit.
NO- Repair or replace error-detected parts.

3. CHECK THROTTLE POSITION SENSOR 1 GROUND CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect ECM harness connector.
3.Check the continuity between electric throttle control actuator harness connector and ECM harness connector.





4.Also check harness for short to power.
Is the inspection result normal?
YES- GO TO 4.
NO- Repair or replace error-detected parts.

4. CHECK THROTTLE POSITION SENSOR 1 INPUT SIGNAL CIRCUIT

1.Check the continuity between electric throttle control actuator harness connector and ECM harness connector.





2.Also check harness for short to ground and to power.
Is the inspection result normal?
YES- GO TO 5.
NO- Repair open circuit or short to ground or short to power in harness or connectors.

5. CHECK THROTTLE POSITION SENSOR

Check the throttle position sensor. .
Is the inspection result normal?
YES- Check intermittent incident. Intermittent Incident.
NO- Replace electric throttle control actuator. Exploded View.


Component Inspection


1. CHECK THROTTLE POSITION SENSOR

1.Turn ignition switch OFF.
2.Reconnect all harness connectors disconnected.
3.Perform " Throttle Valve Closed Position Learning". Work Procedure.
4.Turn ignition switch ON.
5.Set selector lever to D (CVT) or 1st (M/T) position.
6.Check the voltage between ECM harness connector terminals as per the following conditions.





Is the inspection result normal?
YES- INSPECTION END
NO- Replace electric throttle control actuator. Exploded View.