Removal And Installation

AIR BREATHER HOSE

Removal and Installation


REMOVAL

1.Remove air duct (inlet). Removal And Installation.
2.Remove clip from the air duct.
3.Remove air duct. Removal And Installation.
4.Remove clip from the air cleaner case.
5.Remove air breather hose from the 2 way connector.

CAUTION:
When removing air breather hose, be sure to hold 2 way connector securely.

INSTALLATION

Note the following, and install in the reverse order of removal.
- When installing air breather hose on 2 way connector, aim paint mark face toward the vehicle front.
- When installing air breather hose on 2 way connector, push it until it hits transaxle case.
- When installing air breather hose to air cleaner case, make sure that clip are fully inserted.

CAUTION:
Make sure that air breather hose is not collapsed or blocked due to folding or bending when installed.