Removal And Installation

DIFFERENTIAL SIDE OIL SEAL

Removal and Installation


REMOVAL

1.Remove front drive shaft assembly. Exploded View.
2.Remove differential side oil seals using a flat-bladed screwdriver.

CAUTION:
Be careful not to scratch transaxle case and converter housing.

INSTALLATION

Note the following, and install in the reverse order of removal.

CAUTION:
- Never reuse differential side oil seals.
- Apply CVT fluid to differential side oil seals.
- When insert drive shaft, always use a protector [SST: KV-38107900 ( - )]. Exploded View.





Install drive shaft using drifts [SST: ST-35325000 ( - ) and
KV-31103000 ( - )]. Check that side oil seal height difference from case end surface is within the specified value "A" and "B".





NOTE:
Differential side oil seal pulling direction is used as the reference.