Removal And Installation

COWL TOP

Removal and Installation


REMOVAL

1.Fully open hood assembly.
2.Remove front wiper arm, and blades (LH/RH). Removal And Installation.
3.Remove front fender cover. With Intelligent Key System.
4.Remove cowl top cover fixing clips.





5.Pull forward to release cowl top cover from windshield glass.

CAUTION:
When performing the procedure after removing cowl top cover, cover the lower and of windshield glass with urethane etc.
6.Disconnect wind washer tube connector.
7.Remove cowl top cover.
8.Remove the following parts after removing cowl top cover.
- EPT sealer
- Cowl top cover seal
- Washer tube
- Washer nozzles. Removal And Installation.
9.Remove front wiper drive assembly. Removal And Installation.
10.Remove cowl top extension mounting bolts, and them cowl top extension.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
- Always replace cowl top cover EPT sealer on rear of vehicle with a new one when installing old cowl top cover.
- After installing, perform adjustment of wiper arm. Front Wiper Arm.