Removal and Installation

FRONT SEAT

Removal and Installation


REMOVAL


CAUTION:
When removing and installing, use shop cloths to protect parts from damage.
1.Remove the headrest.
2.Remove the mounting bolts on the front side of the front seat.
3.Remove the mounting bolts on the rear side of the front seat.
4.Set seatback in a standing position.
5.Disconnect harness connector under the seat and remove harness securing clips.

CAUTION:
Before removal, turn ignition switch OFF, disconnect battery negative terminal and then wait for at least 3 minutes.
6.Remove seat from the vehicle.

CAUTION:
- When removing and installing, use shop cloths to protect parts from damage.
- When removing and installing, 2 workers are required so as to prevent it from dropping.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
- Before installation, turn ignition switch OFF, disconnect battery negative terminal and then wait for at least 3 minutes.
- Clamp the harness in position.
NOTE:
After installing the passenger seat, perform zero point reset. Description.