Removal And Installation

HEADLINING

Removal and Installation


REMOVAL

1.Remove front body side welt (LH/RH) and rear body side welt (LH/RH). Removal And Installation.
2.Remove front pillar garnish (LH/RH). Removal And Installation.





3.Disconnect microphone harness connector (A).
4.Remove center pillar upper garnish (LH/RH). Removal And Installation.
5.Remove luggage side upper finisher (LH/RH). Removal And Installation.
6.Remove sunvisor assembly mounting screws, and then remove sunvisor assembly (LH/RH).
7.Remove inside mirror cover and then remove inside mirror. Removal And Installation.





8.Disengage room lamp lens fixing pawls with a remover tool, the mounting screws and then remove the room lamp. Removal And Installation.

Broken triangle indicates : Pawl






9.Disengage the map lamp fixing pawls with a remover tool and then remove the map lamp.

Broken triangle indicates : Pawl






10.Remove the assist grips.
- Insert a small minus driver as shown by the arrow in the figure to disengage the fixing pawls.
- Remove the mounting bolts.
- Pull out the assist grip to remove.

Broken triangle indicates : Pawl

11.Rotate the sunvisor holder (LH/RH) at approximately 90 degrees and then pull it down to remove.
12.Remove the headlining clip located at the rear side with a remover tool.





13.Remove the headlining assembly through the back door.

CAUTION:
- When removing headlining, 2 workers are required. (1 for the front and rear of headlining)
- Cover center console finisher upper surface with a shop cloth to prevent it from being damaged.
- Never bend headlining when removing.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
- Never bend headlining when installing.
- When installing, start by installing both sunvisor holders and headlining clips in order to keep the headlining in position.