Removal And Installation

CENTER CONSOLE ASSEMBLY

Removal and Installation


REMOVAL

1.Put selector lever in "N" position (CVT models).
2.Remove shift knob (MT models). Removal And Installation.





3.Remove front console cover.
1.Remove front console cover with a flat-bladed screwdriver (A) wrapped in a tape.
2.Pull up front console cover.

Broken triangle indicates : Pawl

4.Remove mounting nut of center console front side.





5.Remove rear console cover.
1.Remove rear console cover with hook and pick tool (A) as shown in the figure.
2.Pull up rear console cover.

Broken triangle indicates : Pawl

6.Remove mounting nuts of center console rear side.





7.Insert a deep-well socket wrench (A) to rotate adjusting nut to loosen cable sufficiently. Service and Repair.





8.Remove console mask.
1.Pull upward to console mask fixing clips from center console with remover tool (A).
2.Disconnect seat heated switch harness connectors (models with heated seat system).

Broken circle indicates : Clip

9.Lift up center console assembly back side, and then remove center console assembly.

INSTALLATION

Note the following item, and then install in the reverse order of removal.

CAUTION:
After installation, adjust the parking brake lever stroke. Service and Repair.