Diagnosis Procedure LH&RH Front Anti-Pinch Coupe

ENCODER

PASSENGER SIDE : Diagnosis Procedure

Regarding Wiring Diagram information, Coupe With Left And Right Power Window Anti-Pinch.

1. CHECK ENCODER SIGNAL

1.Turn ignition switch ON.
2.Check signal between power window and door lock/unlock switch RH connector and ground with oscilloscope.





Is the inspection result normal?
YES- Check intermittent incident. Intermittent Incident.
NO- GO TO 2

2. CHECK POWER WINDOW MOTOR RH POWER SUPPLY

1.Turn ignition switch ON.
2.Check voltage between power window motor RH connector and ground.





Is the measurement value within the specification?
YES- GO TO 4
NO- GO TO 3

3. CHECK HARNESS CONTINUITY 1

1.Turn ignition switch OFF.
2.Disconnect power window and door lock/unlock switch RH and power window motor RH.
3.Check continuity between power window and door lock/unlock switch RH connector (A) and power window motor RH connector (B).





4.Check continuity between power window and door lock/unlock switch RH connector (A) and ground.





Is the inspection result normal?
YES- Replace power window and door lock/unlock switch RH. LH&RH Front Anti-Pinch Coupe. After that, Special Repair Requirement.
NO- Repair or replace harness.

4. CHECK GROUND CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect power window motor RH.
3.Check continuity between power window motor RH connector and ground.





Is the inspection result normal?

YES- GO TO 6
NO- GO TO 5

5. CHECK HARNESS CONTINUITY 2

1.Disconnect power window and door lock/unlock switch RH.
2.Check continuity between power window and door lock/unlock switch RH connector (A) and power window motor RH connector (B).





Is the inspection result normal?
YES- Replace power window and door lock/unlock switch RH.
LH&RH Front Anti-Pinch Coupe. After that, Special Repair Requirement.
NO- Repair or replace harness.

6. CHECK HARNESS CONTINUITY 3

1.Disconnect power window and door lock/unlock switch RH.
2.Check continuity between power window and door lock/unlock switch RH connector (A) and power window motor RH connector (B).





3.Check continuity between power window and door lock/unlock switch RH connector (A) and ground.





Is the inspection result normal?
YES- Replace power window motor RH. Removal And Installation. After that, refer to
LH&RH Front Anti-Pinch Coupe.
NO- Repair or replace harness.