Coupe

FRONT SEAT

Removal and Installation - Seatback Board


REMOVAL


CAUTION:
- During installation, the wire harness clips must be reinstalled in the holes they were originally in. Do not add additional clips.
NOTE:
If the vehicle has been involved in a collision, the seat must be inspected for damage. For Side And Rollover Collision.
1.Slide the seat to forward position.





2.Remove the seatback board.
NOTE:
The seatback board is attached with the following:
- Two skirt hooks (A)
- Two bottom clips (B)
- Two side clips (C)
- Two top metal hooks (D)





a.From the bottom of the seat, unhook the two seat skirt hooks (<==) as shown.





b.Using a suitable tool, carefully pry the bottom away from the seatback frame to release the seatback board bottom clips (B).
A: Skirt hooks
c.In the same manner, pry the center away from the seatback frame to release the seatback board side clips (C).
d.Carefully push downward to release the top metal hooks (D), and remove the seatback board from the seatback frame.

INSTALLATION

Installation is in the reverse order of removal.