Evaporative Emission Control Canister: Service and Repair

EVAPORATIVE EMISSION SYSTEM


Removal and Installation







EVAP CANISTER

Removal
1. Remove EVAP canister protector.
2. Disconnect the EVAP control pressure sensor connector.
3. Remove the EVAP control pressure sensor and O-ring, if necessary.
4. Disconnect EVAP canister purge hose.
5. Remove the EVAP canister retaining bolt.
6. Disconnect fuel tank EVAP breather hose.
7. Disconnect EVAP vent control valve connector.
8. Disconnect the EVAP vent control valve hose.
9. Remove the EVAP canister.
10. Remove the EVAP vent control valve and O-ring, if necessary.

Installation
Installation is in the reverse order of removal.

CAUTION:
Always replace O-rings with a new one.

EVAP CANISTER CONTROL PRESSURE SENSOR

Removal
1. Remove EVAP canister protector.
2. Disconnect the EVAP control pressure sensor connector.
3. Remove the EVAP canister control pressure sensor and O-ring.

Installation
Installation is in the reverse order of removal.

CAUTION:
Always replace O-ring with a new one.

EVAP CANISTER VENT CONTROL VALVE
1. Remove EVAP canister protector.
2. Disconnect EVAP vent control valve connector.
3. Disconnect the EVAP vent control valve hose.





4. Turn EVAP canister vent control valve counterclockwise.
5. Remove the EVAP canister vent control valve.

Installation
Installation is in the reverse order of removal.

CAUTION:
Always replace O-ring with a new one.