Inspection and Adjustment

BRAKE PEDAL


Inspection and Adjustment


INSPECTION





1. Inspect the brake pedal height (H) from the floor using Tool at a 90� angle to the floor.






2. Adjust the brake pedal height to specification.






ADJUSTMENT





1. Loosen stop lamp switch and ASCD switch (if equipped) by rotating it counterclockwise by 45�.
2. Loosen lock nut on input rod, then rotate input rod to set pedal to the specified height, and tighten lock nut.

CAUTION:
Make sure that the threaded end of input rod stays inside clevis.






3. With the pedal pulled and held by hand, press stop lamp switch or ASCD switch (if equipped) until its threaded end contacts brake pedal lever.
4. With the threaded end of stop lamp switch or ASCD switch (if equipped) contacting brake pedal lever, rotate the switch clockwise by 45� to secure.

CAUTION:
Make sure that the clearance (C) is within the specification.
5. Check that the stop lamps go out when the brake pedal is released

CAUTION:
Make sure that stop lamps go off when brake pedal is released.
6. Start the engine and check the brake pedal for smooth operation.