Cowl Moulding / Trim: Service and Repair

COWL TOP


Removal and Installation












REMOVAL
1. Remove front wiper arms (RH/LH). Service and Repair.





2. Disconnect washer tube.
: Vehicle front
3. Release the clips and remove cowl top seal.
4. Remove the clips and cowl top covers (RH/LH) as necessary.
5. Disconnect and remove the front wiper motor and linkage assembly, if necessary. Service and Repair Service and Repair, "Removal and Installation of Front Wiper Drive Assembly".

CAUTION:
To avoid damage, make sure to cover the lower edge of windshield with suitable protection material.
6. Remove the bolts and cowl extension panel, if necessary.

INSTALLATION
Installation is in the reverse order of removal.

NOTE:
- For wiper arm RH/LH installation and adjustment, Service and Repair.
- Always replace EPT sealer and double-faced adhesive tape when installing cowl top cover.