Front Bumper: Service and Repair

FRONT BUMPER


Removal and Installation












CAUTION:
Bumper fascia is made of resin. Do not apply strong force to it, and be careful to prevent contact with oil.

REMOVAL
1. Remove the front grille. Service and Repair.
2. Remove the screws at front edge of front fender protectors (RH/LH). Component.
3. Remove the clips and splash shields (RH/LH). Component.
4. Remove the screws, clips and engine undercover.
5. Remove upper screws RH/LH from front bumper fascia at front fender.





6. Pull the outboard edge of front bumper fascia away from vehicle to disengage from the bumper side retainer.
7. Disconnect fog lamp harness connectors (RH/LH), if equipped.
8. Remove the front bumper fascia.
9. Remove the screws and fog lamp assemblies (RH/LH), if equipped from bracket. All Except SE-R SE-R, SE-R.
10. Remove the clips and bumper energy absorber.
11. Remove the clips and radiator air guides.
12. Remove the retaining pin (RH/LH) at lower edge, then remove the bolts and bumper reinforcement.
13. Remove bumper side retainer (RH/LH) from front fender.

INSTALLATION





Installation is in the reverse order of removal.

NON SER MODELS











SER MODELS