P1705

P1705 TP SENSOR





Description
Electric throttle control actuator consists of throttle control motor, accelerator pedal position sensor, throttle position sensor etc. The actuator sends a signal to the ECM, and ECM sends the signal to TCM with CAN communication.




CONSULT-III Reference Value









On Board Diagnosis Logic
- This is not an OBD-II self-diagnostic item.
- Diagnostic trouble code "P1705" with CONSULT-III is detected when TCM does not receive the proper accelerator pedal position signals (input by CAN communication) from ECM.




Possible Cause
- ECM
- Harness or connectors
(CAN communication line is open or shorted.)




DTC Confirmation Procedure

NOTE:
If "DTC Confirmation Procedure" has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-III
1. Turn ignition switch ON.
2. Select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
3. Depress accelerator pedal fully and release it, then wait for 5 seconds.
4. If DTC is detected, go to SEE Diagnosis Procedure.




Diagnosis Procedure
1.CHECK CAN COMMUNICATION LINE
Perform the self-diagnosis check. CVT Trouble Diagnosis.
Is any malfunction of the "U1000" indicated?
YES - Check the CAN communication line. CVT CVT CVT CVT.
NO - GO TO 2.
2.CHECK INPUT SIGNAL
With CONSULT-III
1. Turn ignition switch ON.
2. Select "ECU INPUT SIGNALS" in "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
3. Read out the value of "ACC PEDAL OPEN".






OK or NG
OK - GO TO 4.
NG - GO TO 3.
3.CHECK DTC WITH ECM
With CONSULT-III
1. Turn ignition switch ON.
2. Select "SELF-DIAG RESULTS" mode for "ENGINE" with CONSULT-III. CONSULT-III Function (Engine) (For California), "CONSULT-III
CONSULT-III Function (Engine) (Except For California), [MR20DE
(Except for California)] and (QR25DE).
OK or NG
OK - GO TO 4.
NG- Check the DTC Detected Item. Go to CONSULT-III Function (Engine) (For California) [MR20DE (For California)], CONSULT-III Function (Engine) (Except For California), [MR20DE (Except for California)] and .
4. CHECK DTC
Perform SEE DTC Confirmation Procedure.
OK or NG
OK - INSPECTION END
NG - Repair or replace damaged parts.