On Board Diagnosis Function (Combination Meter)

DIAGNOSIS SYSTEM (COMBINATION METER)

On Board Diagnosis Function


ON BOARD DIAGNOSIS ITEM

The combination meter and upper meter allows the following diagnosis items with the on-board diagnosis function.






METHOD OF STARTING

1.Power switch OFF.
2.Turn the power switch ON while holding down the trip reset switch (1).





3.If the diagnosis function is activated with "trip A" displayed, the mileage on "trip A" is reset to "0000.0".
(The same way for "trip B".)
4.Make sure that the trip meter displays "0000.0".
5.Press the trip reset switch at least 3 times (within 7 seconds after power ON).
6.The combination meter and upper meter is turned to self-diagnosis mode.
- The following items are OFF.
- Speedometer
- Power meter
- Li-ion battery temperature gauge
- Li-ion battery capacity level gauge
- Li-ion battery available charge gauge
- Eco indicator
- Driving range display
- Outside air temperature display
- Clock display
- Information display
NOTE:
- Check the following items when the self-diagnosis mode of the combination meter does not start.
Replace combination meter if the following items are normal
- Combination meter power supply and ground circuit.
- Meter control switch signal circuit (trip A/B reset switch signal circuit) and meter control switch.
- Check the following items when the self-diagnosis mode of the upper meter does not start. Replace upper meter if the following items are normal
- Upper meter power supply and ground circuit.
- Communication line (METER --> UPPER)
7.The segments and information display turn ON while the trip reset switch is depressed.





NOTE:
- If there is a segment that does not turn ON, replace the combination meter or upper meter.
- If the information display does not turn ON, replace the combination meter.