Removal And Installation

PARKING BRAKE REAR CABLE

Removal and Installation


REMOVAL

1.Turn the power switch ON.

CAUTION:
Never set the vehicle to READY.
2.Release the parking brake.

CAUTION:
If the brake cannot be released, release it manually. Refer to "Parking Brake Actuator" Description and Operation.
3.Turn the power switch OFF.
4.Disconnect 12V battery negative terminal. Refer to "Precaution for Removing 12V Battery" Precaution For Removing 12V Battery.





5.Loosen adjust nut (1).
6.Remove rear cable with the following procedure.





a.Pull equalizer (1) in forward direction.
b.Pull rear cable (2) downward to remove rear cable from equalizer.





c.Press the paw (1) to remove cable from bracket.
d.Remove bracket from vehicle.

INSTALLATION

Note the following, and install in the reverse order of removal.





- Tighten the adjust nut (1) so that the bolt (A) is within dimension B.
B: 13 15 mm (0.51 0.59 in)
- Perform parking brake actuator 0 point learning when parking brake actuator, parking brake rear cables and parking brake shoe are removed and installed, or replaced. Refer to "Work Procedure" Work Procedure.
- Perform adjustment after installation. Refer to "Inspection" Inspection.