Adjustment

CHARGE PORT LID

CHARGE PORT LID ASSEMBLY : Adjustment











Check the clearance and the surface height between charge port lid and each part by visually and touching.
If the clearance and the surface height are out of specification, adjust them according to the procedures shown below.
Difference


PortionStandard (RH/LH,
MAX)
EClearance2.3 - 7.7 mm (0.091 - 0.303 in)Charge port lid -
A - A
(-1.0) - (+3.0) mm [(-0.039) -
Hood
FSurface height(+0.118) in]
Charge port lid - 2.9 mm
B - BGClearance2.3 - 7.7 mm (0.091 - 0.303 in)
Hood (0.114 in)
Difference
PortionStandard (RH/LH,
MAX)
2.9 mm
HClearance1.4 - 3.8 mm (0.055 - 0.150 in)
(0.114)
Charge port lid -
C - C
Front bumper fascia 1.9 mm
ISurface height0.0 - 3.0 mm (0.000 - 0.118 in)
(0.075 in)
JClearance2.1 - 4.5 mm (0.083 - 0.177 in)Charge port lid -
D - D
Front bumper fascia
KSurface height2.0 - 5.0 mm (0.079) - (0.197 in)-

FITTING ADJUSTMENT PROCEDURE

1.Remove charge port cover. Refer to "CHARGE PORT COVER : Removal and Installation" Charge Port Cover.
2.Remove charge port lid lock.
3.Loosen charge port lid assembly mounting nuts.
4.Adjust the clearance of charge port lid assembly, hood assembly and front bumper fascia according to the specified value, by moving charge port lid assembly.
5.Tighten charge port lid.
6.Temporarily tighten charge port lid lock.
7.Adjust the surface height of charge port lid assembly, hood assembly and front bumper fascia according to the specified value, by moving charge port lid lock.
8.After adjustment, tighten charge port lid lock mounting bolts.
9.Install charge port cover. Refer to "CHARGE PORT COVER : Removal and Installation" Charge Port Cover.