Front Seat Belt

FRONT SEAT BELT


SEAT BELT RETRACTOR : Removal and Installation


REMOVAL

WARNING:
Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait 3 minutes or more.
1. Remove shoulder anchor.
1. Slide driver seat to the frontmost position.




Broken Triangle : Pawl

2. Pull adjuster cover in direction indicated by arrows as shown in the figure. Remove adjuster cover.

3. Remove shoulder anchor mounting anchor bolt.
2. Remove outer anchor mounting anchor bolt, and then remove outer anchor.
3. Remove front kicking plate inner and rear kicking plate inner. Service and Repair.
4. Remove center pillar lower garnish. Center Pillar Lower Garnish.
5. Remove seat belt pretensioner retractor.

Driver side
1. Remove seat belt pretensioner retractor mounting anchor bolt and screw.
2. Disconnect seat belt pretensioner harness connector.

CAUTION:





- For installing/removing seat belt pretensioner connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove connector.
- Install connector with lock raised, and push lock into connector.
- After installing the connector, check that the lock is pushed securely into it.
- Never place pretensioner seat belt in an area where the temperature reaches 80�C or more.

Passenger side
1. Disconnect seat belt pretensioner harness connector.

CAUTION:





- For installing/removing seat belt pretensioner connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove connector.
- Install connector with lock raised, and push lock into connector.
- After installing the connector, check that the lock is pushed securely into it.
2. Remove seat belt pretensioner retractor mounting anchor bolt and screw.

CAUTION:
Never place pretensioner seat belt in an area where the temperature reaches 80�C or more.
6. Remove seat belt adjuster.
1. Remove center pillar upper garnish. Center Pillar Upper Garnish.
2. Remove seat belt adjuster mounting anchor bolts.

INSTALLATION
Install in the reverse order of removal.