Without Intelligent Key System

HAZARD FUNCTION





Component Function Check
1.CHECK FUNCTION
1. Select "MULTI REMOTE ENT" of "BCM" using CONSULT-III.
2. Select "FLASHER" in "ACTIVE TEST" mode.
3. Check that the function operates normally according to the following conditions.





Is the inspection result normal?
YES - Hazard warning lamp circuit is OK.
NO - SEE Diagnosis Procedure.




Diagnosis Procedure
1.CHECK HAZARD SWITCH CIRCUIT
Hazard Switch.
Is the inspection result normal?
YES - GO TO 2.
NO - Repair or replace the malfunctioning parts.
2.CHECK INTERMITTENT INCIDENT
Intermittent Incident.
- INSPECTION END