Thermo Control Amplifier Removal And Installation

THERMO CONTROL AMPLIFIER


Removal and Installation


REMOVAL
1. Remove evaporator. Service and Repair.
2. Remove thermo control amp. from evaporator.

INSTALLATION
Note the following items, and then install in the reverse order of removal.

CAUTION:
- Replace O-ring with new one. Then apply compressor oil to them when installing.
- When install the thermo control amp., set the same position before replacement.
- When remove the thermo control amp., never turn the bracket which is equipped the top of the thermo control amp.
- Check for the leakages when recharging refrigerant. Leak Test.