Removal and Installation

PARKING BRAKE CONTROL


Removal and Installation


REMOVAL
1. Remove rear tires with power tool.
2. Remove the center console assembly. Removal And Installation.
3. Disconnect the parking brake switch harness connector.





4. Remove adjusting nut (1) and loosen front cable.
5. Remove the parking brake lever assembly.





6. Remove rear cable with the following procedure.
a. Pull equalizer (A) of the front cable (1) in a rearward direction.
b. Push the equalizer upward to remove the rear cable (2).
7. Remove center muffler and heat plate. Removal And Installation.
8. Remove brake shoe, and remove rear cable from toggle lever. Exploded View.
9. Remove rear cable mounting bolts, pull out rear cable from vehicle.





10. Press the pawl (1) to remove the rear cable from the vehicle.

INSTALLATION
Note the following, install in the reverse order of the removal.
- Never reuse adjusting nut.
- Perform adjustment after installation. Inspection.