P0725

P0725 ENGINE SPEED





Description
The engine speed signal is transmitted from ECM to TCM by CAN communication line.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE

CAUTION:
Always drive vehicle at a safe speed.
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
- GO TO 2.
2.CHECK DTC DETECTION
With CONSULT-III
1. Start the engine.
2. Select "Data Monitor" in "TRANSMISSION".
3. Select "PRI SPEED".
4. Drive the vehicle.
5. Maintain the following condition for 10 seconds or more.





6. Stop the vehicle.
7. Select "Self Diagnostic Results in "TRANSMISSION".
Is "P0725" detected?
YES - Go to SEE Diagnosis Procedure.
NO - INSPECTION END




Diagnosis Procedure
1. CHECK DTC (ECM)
With CONSULT-III
1. Turn ignition switch ON.
2. Select "Self Diagnostic Results" in "ENGINE".
Is any DTC detected?
YES - Check DTC detected item. Testing and Inspection.
NO - Check intermittent incident. Intermittent Incident.