P0705

P0705 TRANSMISSION RANGE SWITCH A





DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE

CAUTION:
Always drive vehicle at a safe speed.
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
- GO TO 2.
2.CHECK DTC DETECTION
With CONSULT-III
1. Start engine.
2. Shift the selector lever through entire positions from "P" to "D". (Hold the selector lever at each position for
5 seconds or more.)
3. Select "Self Diagnostic Results" in "TRANSMISSION".
With GST
Follow the procedure "With CONSULT-III".
Is "P0705" detected?
YES - Go to SEE Diagnosis Procedure.
NO - INSPECTION END




Diagnosis Procedure
1.CHECK TRANSMISSION RANGE SWITCH POWER CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect transmission range switch connector.
3. Turn ignition switch ON.
4. Check voltage between transmission range switch harness connector terminal and ground.





Is the check result normal?
YES - GO TO 2.
NO - GO TO 6.
2.CHECK HARNESS BETWEEN TCM AND TRANSMISSION RANGE SWITCH (PART 1)
1. Turn ignition switch OFF.
2. Disconnect TCM connector.
3. Check continuity between TCM harness connector terminals and transmission range switch harness connector terminals.





Is the check result normal?
YES - GO TO 3.
NO - Repair or replace damaged parts.
3.CHECK HARNESS BETWEEN TCM AND TRANSMISSION RANGE SWITCH (PART 2)
Check continuity between TCM harness connector terminals and ground.





Is the check result normal?
YES - GO TO 4.
NO - Repair or replace damaged parts.
4.CHECK TRANSMISSION RANGE SWITCH MOUNTING POSITION
1. Remove control cable from manual lever. Exploded View.
2. Check transmission range switch mounting position. Inspection And Adjustment.
Is the check result normal?
YES - GO TO 5.
NO - Adjust transmission range switch mounting position.
5.CHECK TRANSMISSION RANGE SWITCH
1. Install control cable to manual lever. Exploded View.
2. Check transmission range switch. SEE Component Inspection (Transmission Range Switch).
Is the check result normal?
YES - Check intermittent incident. Intermittent Incident.
NO - Replace transmission range switch.
6.CHECK HARNESS BETWEEN TRANSMISSION RANGE SWITCH AND IPDM E/R (PART 1)
1. Turn ignition switch OFF.
2. Disconnect IPDM E/R connector.
3. Check continuity between transmission range switch harness connector terminals and IPDM E/R harness connector terminal.





Is the check result normal?
YES - GO TO 7.
NO - Repair or replace damaged parts.
7.CHECK HARNESS BETWEEN TRANSMISSION RANGE SWITCH AND IPDM E/R (PART 1)
Check continuity between transmission range switch harness connector terminals and ground.





Is the check result normal?
YES - GO TO 8.
NO - Repair or replace damaged parts.
8.DETECT MALFUNCTIONING ITEM
Check the following items:
- Harness open circuit or short circuit between the ignition switch and IPDM E/R. Ignition Power Supply.
- 10A fuse (No.55, IPDM E/R). Fuse, Connector And Terminal Arrangement.
- IPDM E/R
Is the check result normal?
YES - Check intermittent incident. Intermittent Incident.
NO - Repair or replace damaged parts.




Component Inspection (Transmission Range Switch)
1.CHECK TRANSMISSION RANGE SWITCH
Check continuity between transmission range switch connector terminals.





Is the inspection result normal?
YES - INSPECTION END
NO - Replace transmission range switch. Removal And Installation.