Removal And Installation

FRONT SEAT BELT


SEAT BELT RETRACTOR : Removal and Installation


REMOVAL

CAUTION:
Before servicing SRS, turn the ignition switch OFF, disconnect battery negative terminal and wait at least 3 minutes.

REMOVAL
1. Remove shoulder anchor.
- Remove shoulder anchor cover.
- Remove fixing anchor bolt of the shoulder anchor.
2. Remove outer anchor mounting bolt.
3. Remove seat belt pretensioner retractor.
- Remove center pillar lower finisher. Removal And Installation.
- Disconnect the seat belt pretensioner connector.





CAUTION:
- For installing/removing seat belt pretensioner connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove connector.
- Install connector with lock raised, and push lock into connector.
- After installing the connector, check that the lock is pushed securely into it.
- Remove the fixing bolt and anchor bolt of the seat belt pretensioner retractor.
4. Remove the seat belt adjuster.
Remove the fixing bolts of the seat belt adjuster.

INSTALLATION
Install in the reverse order of removal.