U1200

TROUBLE DIAGNOSIS FOR SYSTEM


DTC U1200 CAN VHCL SPEED ABS


CONSULT-III REFERENCE VALUE IN DATA MONITOR MODE






DIAGNOSTIC PROCEDURE
1.CHECK DTC WITH ABS
Perform self-diagnosis with ABS actuator and electric unit (control unit). Refer to Scan Tool Testing and Procedures.
Is any malfunction detected by self-diagnosis?
YES >> Check the malfunctioning system.
NO >> GO TO 2.
2.CHECK EPS CONTROL UNIT
Check EPS control unit input/output signal. Refer to EPS Control Unit Input/Output Signal Reference Value.
OK or NG
OK >> GO TO 3.
NG >> Check EPS control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts.
3. CHECK DTC
Perform the self-diagnosis, after driving the vehicle for a while.
OK or NG
OK >> INSPECTION END
NG >> Perform self-diagnosis with ABS actuator and electric unit (control unit). Refer to Scan Tool Testing and Procedures.