U1200

DTC U1200 CAN VHCL SPEED ABS

CONSULT-III REFERENCE VALUE IN DATA MONITOR MODE:

DIAGNOSTIC PROCEDURE

1.CHECK DTC WITH ABS
Perform self-diagnosis with ABS actuator and electric unit (control unit). Refer to BRC-18, "CONSULT-III Function (ABS)". Consult-III Function (ABS)
Is any malfunction detected by self-diagnosis?
YES >> Check the malfunctioning system.
NO >> GO TO 2.

2.CHECK EPS CONTROL UNIT
Check EPS control unit input/output signal. Refer to STC-9, "EPS Control Unit Input/Output Signal Reference Value". EPS Control Unit Input/Output Signal Reference Value
OK or NG
OK >> GO TO 3.
NG >> Check EPS control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts.

3.CHECK DTC
Perform the self-diagnosis, after driving the vehicle for a while.
OK or NG
OK >> INSPECTION END
NG >> Perform self-diagnosis with ABS actuator and electric unit (control unit). Refer to BRC-18, "CONSULT-III Function (ABS)". Consult-III Function (ABS)