Diagnostic Procedure 3

DIAGNOSTIC PROCEDURE 3

Final Check of SRS Using CONSULT-III Diagnosis Mode
1. If no DTC is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed. Go to step 2.
If any DTC is detected on "SELF-DIAG [CURRENT]", the malfunctioning part has not been repaired completely or another malfunctioning part is being detected. Go to SRS-22, "DIAGNOSTIC PROCEDURE 2". Diagnostic Procedure 2

2. Touch "ERASE".

NOTE:
- Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST]").
- If the memory of the malfunction in "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.

3. Touch "BACK" on CONSULT-III screen. Touch "SELF-DIAG [PAST]".
4. Check that no malfunction is detected on "SELF-DIAG [PAST]".
5. Touch "BACK" on CONSULT-III screen to return to User mode from Diagnosis mode.
6. Turn ignition switch OFF then turn off and disconnect CONSULT-III.
7. Go to SRS-20, "Checking SRS Operation Using "AIR BAG" Warning Lamp-User Mode". [1][2]Component Tests and General Diagnostics