P1723

DTC P1723 CVT SPEED SENSOR FUNCTION

Description
- The vehicle speed sensor CVT [output speed sensor (secondary speed sensor)] detects the revolution of the parking gear and generates a pulse signal. The pulse signal is sent to the TCM, which converts it into vehicle speed.
- The input speed sensor (primary speed sensor) detects the primary pulley revolution speed and sends a signal to the TCM.

On Board Diagnosis Logic
- This is not an OBD-II self-diagnostic item.
- Diagnostic trouble code P1723 CVT SPD SEN/FNCTN with CONSULT-III is detected when there is a great difference between the vehicle speed signal and the secondary speed sensor signal.

CAUTION: One of the P0720 VEH SPD SEN/CIR AT, the P0715 INPUT SPD SEN/CIRC or the P0725 ENGINE SPEED SIG is displayed with the DTC at the same time.

Possible Cause
- Harness or connectors
(Sensor circuit is open or shorted.)
- Output speed sensor (Secondary speed sensor)
- Input speed sensor (Primary speed sensor)
- Engine speed signal system

DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.

NOTE: If DTC Confirmation Procedure has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

After the repair, touch ERASE on SELF-DIAG RESULTS and then perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-III
1. Turn ignition switch ON and select DATA MONITOR mode for TRANSMISSION with CONSULT-III.
2. Start engine and maintain the following conditions for at least 5 consecutive seconds.
VEHICLE SPEED SE: 10 km/h (6 MPH) or more
ACC PEDAL OPEN: More than 1.0/8
RANGE: D position
ENG SPEED: 450 rpm or more
Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.
3. If DTC is detected, go to CVT-143, "Diagnostic Procedure".

Diagnostic Procedure
1. CHECK STEP MOTOR FUNCTION
Perform the self-diagnosis check. Refer to CVT-54, "SELF-DIAGNOSTIC RESULT MODE". With Manufacturer's Scan Tool
Is a malfunction in the step motor function indicated in the results?
YES >> Repair or replace damaged parts. (Check the step motor function. Refer to CVT-156, "DTC P1778 STEP MOTOR - FUNCTION". P1778)
NO >> GO TO 2.

2. CHECK OUTPUT SPEED SENSOR (SECONDARY SPEED SENSOR SYSTEM) AND INPUT SPEED SENSOR (PRIMARY SPEED SENSOR) SYSTEM
Check output speed sensor (secondary speed sensor) system and input speed sensor (primary speed sensor) system. Refer to CVT-83, "DTC P0720 VEHICLE SPEED SENSOR CVT (SECONDARY SPEED SENSOR)". P0720
Refer to CVT-77, "DTC P0715 INPUT SPEED SENSOR CIRCUIT (PRI SPEED SENSOR)". P0715
OK or NG
OK >> GO TO 3.
NG >> Repair or replace damaged parts.

3. CHECK ENGINE SPEED SIGNAL SYSTEM
Check engine speed signal system. Refer to CVT-89, "DTC P0725 ENGINE SPEED SIGNAL". P0725
OK or NG
OK >> GO TO 4.
NG >> Repair or replace damaged parts.

4. DETECT MALFUNCTIONING ITEM
Check the following:
- Power supply and ground circuit for TCM. Refer to CVT-134, "DTC P1701 TRANSMISSION CONTROL MODULE (POWER SUPPLY)". P1701
- The TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK >> GO TO 5.
NG >> Repair or replace damaged parts.

5. CHECK DTC
Perform CVT-142, "DTC Confirmation Procedure".
OK or NG
OK >> INSPECTION END
NG >> Replace TCM or transaxle assembly.