P0442

DTC P0442 EVAP CONTROL SYSTEM




On Board Diagnosis Logic
This diagnosis detects leaks in the EVAP purge line using engine intake manifold vacuum.

If pressure does not increase, the ECM will check for leaks in the line between the fuel tank and EVAP canister purge volume control solenoid valve, under the following Vacuum test conditions.

The EVAP canister vent control valve is closed to shut the EVAP purge line off. The EVAP canister purge volume control solenoid valve will then be opened to depressurize the EVAP purge line using intake manifold vacuum. After this occurs, the EVAP canister purge volume control solenoid valve will be closed.

CAUTION:
- Use only a genuine NISSAN fuel filler cap as a replacement. If an incorrect fuel filler cap is used, the MIL may come on.
- If the fuel filler cap is not tightened properly, the MIL may come on.
- Use only a genuine NISSAN rubber tube as a replacement.

DTC Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:
- Perform "DTC WORK SUPPORT" when the fuel level is between 1/4 and 3/4 full, and vehicle is placed on flat level surface.
- Always perform test at a temperature of 0 to 10 °C (32 to 140 °F).
- Open engine hood before conducting following procedure.

WITH CONSULT-III
1. Turn ignition switch ON.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-III.
4. Check the following conditions are met.
COOLAN TEMP/S: 0 - 100 °C (32 - 212 °F)
INT/A TEMP SE: 0 - 60 °C (32 - 140 °F)

5. Select "EVAP SML LEAK P0442/P1442" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT-III.
Follow the instruction displayed.

NOTE: If the engine speed cannot be maintained within the range displayed on the CONSULT-III screen, go to EC-71, "Basic Inspection". Preinspections

6. Make sure that "OK" is displayed.
If "NG" is displayed, Refer to "Diagnostic Procedure" below.

WITH GST

NOTE: Be sure to read the explanation of Driving Pattern on "Driving Pattern" before driving vehicle. Driving Pattern

1. Start engine.
2. Drive vehicle according to Driving Pattern, "Driving Pattern".
3. Stop vehicle.
4. Turn ignition switch OFF and wait at least 10 seconds and then turn ignition switch ON.
5. Select Service $07 with GST.
- If P0442 is displayed on the screen, go to "Diagnostic Procedure" below.
- If P0441 is displayed on the screen, go to "Diagnostic Procedure" for DTC P0441.

Diagnostic Procedure

Step 1-4:

Step 5-6:

Step 7-9:

Step 10-14:

Step 15-22:

Step 23-24: