Diagnostic Procedure 5

Inspecting SRS intermittent malfunction by using CONSULT-II - Diagnosis mode




1. Turn ignition switch "OFF".




3. Turn ignition switch "ON".
4. Touch "START'.




5. Touch "AIR BAG".




6. Touch "SELF-DIAG [PAST]".




7. If diagnostic codes are displayed on "SELF-DIAG [PAST]", go to step 10.




If no malfunction is detected on "SELF-DIAG [PAST]", touch "BACK" and go back to "SELECT DIAG MODE".

NOTE: Past malfunction for front seat belt pre-tensioner system will not be displayed on "SELF-DIAG [PAST]".




8. Touch "TROUBLE DIAG RECORD".

NOTE: With "TROUBLE DIAG RECORD", diagnosis results previously erased by a reset operation can be displayed.




9. Diagnostic code is displayed on "TROUBLE DIAG RECORD".
10. Touch "PRINT".
11. Compare diagnostic codes to "Intermittent Malfunction Diagnostic Code Chart ("SELF-DIAG [PAST]" or 'TROUBLE DIAG RECORD")".
12. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears.
13. Turn ignition switch "OFF", then turn off and disconnect CONSULT-II, and both battery cables.

INTERMITTENT MALFUNCTION DIAGNOSTIC CODE CHART (SELF-DIAG [PAST] OR TROUBLE DIAG RECORD):

14. Repair the system as outlined by the "Repair order" in "Intermittent Malfunction Diagnostic Code Chart", that corresponds to the self-diagnostic result. For replacement procedure of component parts.
15. Refer to "DIAGNOSTIC PROCEDURE 3" Diagnostic Procedure 3 for final checking.