P0710

Description








The ACT fluid temperature sensor detects the A/T fluid temperature and sends a signal to the PCM.





CONSULT-II REFERENCE VALUE IN DATA MONITOR MODE





ON BOARD DIAGNOSIS LOGIC

DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE

CAUTION: Always drive vehicle at a safe speed.

NOTE: If "DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

With CONSULT-II








1) Turn ignition switch "ON" and select "DATA MONITOR" mode for "ENGINE" with CONSULT-II.
2) Start engine and maintain the following conditions for at least 10 minutes (Total). (It is not necessary to maintain continuously.)
CMPS.RPM (REP): 450 rpm or more
VHCL SPEED SE: 10 km/h (6 MPH) or more
THRTL POS SEN: More than 1.2 V
Selector lever: D position (OD "ON")

With GST
Follow the procedure "With CONSULT-II".





Wiring Diagram

Diagnostic Procedure Steps 1 - 2:

Diagnostic Procedure Steps 3 - 4:

Step 5:

Diagnostic Procedure

Component Inspection
A/T FLUID TEMPERATURE SENSOR








- Check resistance between two terminals while changing temperature as shown.