Collision Diagnosis
FOR FRONTAL COLLISIONTo repair the SRS for a frontal collision, perform the following steps.
When SRS (except the side air bag) is activated in a collision:
1. Replace the diagnosis sensor unit.
2. Remove the air bag modules (except the side air bag module).
3. Check the SRS components using the table shown:
Replace any SRS components showing visible signs of damage (dents, cracks, deformation).
4. Install new air bag modules(except the side air bag module).
5. Conduct self-diagnosis using CONSULT-II, "AIR BAG" and "SEAT BELT' warning lamps. Refer to "Self-diagnosis" for details.
SEE DIAGNOSTIC PROCEDURE 1 AND 2.
[1][2]Component Tests and General Diagnostics
[1][2]Component Tests and General Diagnostics
Ensure entire SRS operates property.
Part 1 Of 2:
Part 2 Of 2:
When SRS is not activated in a collision:
1. Check the SRS components using the table shown below:
Replace any SRS components showing visible signs of damage (dents, cracks, deformation).
2. Conduct self-diagnosis using CONSULT-II, "AIR BAG" and "SEAT BELT' warning lamps. Refer to "Self-diagnosis" for details. Ensure entire SRS operates properly.
FOR SIDE COLLISION
To repair the SRS for a side collision, perform the following steps.
When the side air bag is activated in the side collision:
1. Replace the following component:
- Diagnosis sensor unit
- Satellite sensor (on the side on which side air bag is activated)
2. Remove the deployed side air bag module.
3. Check the SRS components and the related parts showing visible signs of damage (dents, cracks, deformation).
4. Install new side air bag module (on the side on which side air bag has been activated) with new nuts.
5. Conduct self-diagnosis using CONSULT II, and "AIR BAG" and "SEAT BELT" warning lamp. Refer to "SRS Operation Check" for details. SEE DIAGNOSTIC PROCEDURE 1 AND 2.
[1][2]Component Tests and General Diagnostics
[1][2]Component Tests and General Diagnostics
Ensure entire SRS operates properly.
1 Of 2:
2 Of 2:
When SRS is not activated in the side collision:
1. Check the SRS components and the related parts using the table shown in the diagram.
Replace any SRS components and the related parts showing visible signs of damage (dents, cracks, deformation).
2. Conduct self-diagnosis using CONSULT II, and "AIR BAG" and "SEAT BELT" warning lamp. Refer to "Self-diagnosis" for details. Ensure entire SRS operates properly.