Diagnostic Procedure 4

Final checking after repairing SRS by using CONSULT II - Diagnosis mode





1. After repairing SRS, connect both battery cables.
2. Connect CONSULT-II to Data link connector.
3. Turn ignition switch from "OFF" to "ON".





4. Touch "START".





5. Touch "AIRBAG".





6. Touch "SELF-DIAG [CURRENT]".





7. If no malfunction is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed.
If any malfunction is detected on "SELF-DIAG [CURRENT]", the malfunctioning part is not repaired completely or another malfunctioning pan is detected. Go to DIAGNOSTIC PROCEDURE 2, Diagnostic Procedure 2and repair malfunctioning part completely.





8. Touch "ERASE".

NOTE: Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST]").

If the memo of the malfunction is "SELF-DIAG [PAST]" is not erased, The User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.





9. Touch "BACK " key of CONSULT-II to select "SELF-DIAG [PAST]" in the "SELECT DIAG MODE" screen. Touch "SELF-DIAG [PAST]".





10. Check that no malfunction is detected on "SELF-DIAG [PAST]".
11. Touch "BACK "key of CONSULT-II until SELECT SYSTEM appears in order to return to User mode from Diagnosis mode, turn ft CONSULT-II, then disconnect CONSULT-II.
12. Turn ignition switch "OFF".
13. Go to DIAGNOSTIC PROCEDURE 1 [1][2]Component Tests and General Diagnosticsto check SRS operation by using "AIR BAG" warning lamp with User mode.