P0710

DESCRIPTION








The A/T fluid temperature sensor detects the A/T fluid temperature and sends a signal to the TCM.





CONSULT REFERENCE VALUE IN DATA MONITOR MODE





TCM TERMINALS AND REFERENCE VALUE





ON BOARD DIAGNOSIS LOGIC

DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE

CAUTION:
- Always drive vehicle at a safe speed.
- If conducting this "DTC CONFIRMATION PROCEDURE" again, always turn ignition switch "OFF" and wait at least 5 seconds before continuing.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

With CONSULT-II








1) Turn ignition switch "ON" and select "DATA MONITOR" mode for "ENGINE" with CONSULT-II.
2) Start engine and maintain the following conditions for at least 10 minutes (Total). (It is not necessary to maintain continuously.)
CMPS-RPM (REF): 450 rpm or more
VHCL SPEED SE: 10 km/h (6 MPH) or more
THRTL POS SEN: More than 1.2 V
Selector lever: D position (OD "ON")

With GST
Follow the procedure "With CONSULT-II".





WIRING DIAGRAM - AT - FTS





DIAGNOSTIC PROCEDURE

COMPONENT INSPECTION
A/T fluid temperature sensor








- Check resistance between two terminals while changing temperature as shown.