P0710

DESCRIPTION
The A/T fluid temperature sensor detects the A/T fluid temperature and sends a signal to the TCM.






CONSULT REFERENCE VALUE IN DATA MONITOR MODE






TCM TERMINALS AND REFERENCE VALUE






ON BOARD DIAGNOSIS LOGIC


DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE

CAUTION: Always drive vehicle at a safe speed.

NOTE: If "DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.


With Generic Scan Tool
(1) Start engine.
(2) Drive vehicle under the following conditions: Selector lever in "D" position (OD "ON"), vehicle speed higher than 10 km/h (6 MPH), throttle opening greater than 1/8 of the full open position, engine speed higher than 450 rpm and driving for more than 10 minutes (Total).
(3) Select "MODE 7" with GST.






DIAGNOSTIC PROCEDURE



COMPONENT INSPECTION
A/T fluid temperature sensor












Check resistance between two terminals while changing temperature as shown.