DTC 0908

COMPONENT DESCRIPTION
The engine coolant temperature sensor is used to detect the engine coolant temperature. The sensor modifies a voltage signal from the ECM. The modified signal returns to the ECM as the engine coolant temperature input. The sensor uses a thermistor which is sensitive to the change in temperature. The electrical resistance of the thermistor decreases as temperature increases.






CONSULT REFERENCE VALUE IN DATA MONITOR MODE
Specification data are reference values.






ON BOARD DIAGNOSIS LOGIC


DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE

CAUTION: Be careful not to overheat engine.

NOTE:
- If both DTC P0115 (0103) and P0125 (0908) are displayed, first perform "TROUBLE DIAGNOSIS FOR DTC P0115".
- If "DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.


Without Scan Tools
(1) Start engine and run it for 15 minutes at idle speed.
(2) Turn ignition switch "OFF", wait at least 5 seconds and then turn "ON".
(3) Perform "Diagnostic Test Mode II (Self-diagnostic results)" with ECM.
If "COOLAN TEMP/S" increases to more than 25°C (77°F) within 15 minutes, stop engine because the test result will be OK.






Electrical Diagrams






Circuit Connectors






DIAGNOSTIC PROCEDURE













COMPONENT INSPECTION
Engine coolant temperature sensor
Check resistance as shown in the figure.

If NG, replace engine coolant temperature sensor.