DTC 0902

Rear Heated Oxygen Sensor Heater (Right bank) (DTC: 0902)
SYSTEM DESCRIPTION
The ECM performs ON/OFF control of the rear heated oxygen sensor heaters corresponding to the engine speed.




OPERATION




DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE
With Consult
1) Turn ignition switch "ON" and select "DATA MONITOR" mode with CONSULT
2) Start engine and run it for at least 5 seconds at idle speed.

OR

With GST
1) Start engine and run it for at least 5 seconds at idle speed.
2) Select "MODE 3" with GST.

OR

Without Scan Tools
1) Start engine and run it for at least 5 seconds at idle speed.
2) Turn ignition switch "OFF", wait at least 5 seconds and then turn "ON".
3) Perform "Diagnostic Test Mode II (Self-diagnostic results)" with ECM.




WIRING DIAGRAM




DIAGNOSTIC PROCEDURE

COMPONENT INSPECTION
Rear heated oxygen sensor heater
Check the following.




1. Check resistance between terminals (4) and (1).

Resistance: 2.3 - 4.3 Ohms at 25°C (77°F)




2. Check continuity.
If NG, replace the rear heated oxygen sensor.

CAUTION: Discard any heated oxygen sensor which has been dropped from a height of more than 0.5 m (19.7 in) onto a hard surface such as a concrete floor; use a new one.