P0441

DTC P0441 EVAP CONTROL SYSTEM

System Description

NOTE: If DTC P0441 is displayed with P0510, perform trouble diagnosis for DTC P0510 first. (See "DTC P0510 CLOSED TP SWITCH".)




In this evaporative emission (EVAP) control system, purge flow occurs during non-closed throttle conditions. Purge volume is related to air intake volume. Under normal purge conditions (non-closed throttle), the EVAP canister purge volume control solenoid valve is open. Purge flow exposes the EVAP control system pressure sensor to intake manifold vacuum.




On Board Diagnosis Logic
Under normal conditions (non-closed throttle), sensor output voltage indicates if pressure drop and purge flow are adequate. If not, a malfunction is determined.

DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.

NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch OFF and wait at least 5 seconds before conducting the next test.

TESTING CONDITION:
Always perform test at a temperature of 5 °C (41 °F) or more.

WITH CONSULT-II
1. Start engine and warm it up to normal operating temperature.
2. Turn ignition switch OFF and wait at least 5 seconds.
3. Start engine and let it idle for at least 70 seconds.
4. Select "PURG FLOW P0442" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT-II.
5. Touch "START".
If "COMPLETED" is displayed, go to step 7.







6. When the given conditions are met, "TESTING" will be displayed on the CONSULT-II screen. Maintain the conditions continuously until "TESTING" changes to "COMPLETED". (It will take at least 35 seconds.)
If "TESTING" is not changed for a long time, retry from step 2.
7. Make sure that "OK" is displayed after touching "SELF-DIAG RESULTS". If "NG" is displayed, refer to "Diagnostic Procedure" below.

Overall Function Check
Use this procedure to check the overall monitoring function of the EVAP control system purge flow monitoring. Daring this check, a DTC might not be confirmed.

WITH GST
1. Lift up drive wheels.
2. Start engine and warm it up to normal operating temperature.
3. Turn ignition switch OFF, wait at least 5 seconds.
4. Start engine and wait at least 70 seconds.




5. Set voltmeter probes to ECM terminals 62 (EVAP control system pressure sensor signal) and ground.
6. Check EVAP control system pressure sensor value at idle speed and note it.




7. Establish and maintain the given conditions for at least 1 minute.
8. Verify that EVAP control system pressure sensor value stays 0.1 V less than the value at idle speed (measured at step 6) for at least 1 second.
9. If NG, go to "Diagnostic Procedure" below.

Diagnostic Procedure

Diagnostic Procedure Step 1 - 2:

Diagnostic Procedure Step 3 - 5:

Diagnostic Procedure Step 6 - 8:

Diagnostic Procedure Step 9 - 11:

Diagnostic Procedure Step 12:

Diagnostic Procedure Step 13 - 16: