Collision Diagnosis

To repair the SRS, perform the following steps.

When SRS is activated in a collision:

1. Replace the air bag diagnosis sensor unit.
2. Remove the air bag modules.
3. Check the SRS components using the table shown:
Replace any SRS components showing visible signs of damage (dents, cracks and deformation).

4. Install new air bag modules.
5. Conduct Self-diagnosis using CONSULT-II or "AIR BAG" warning lamp. Refer to "SRS Operation Check"for details. [1][2]Component Tests and General DiagnosticsEnsure entire SRS operates properly.

Part 1 Of 2:

Part 2 Of 2:

When SRS is not activated in a collision:
1. Check the SRS components using the table shown below:
Replace any SRS components showing visible signs of damage (dents, cracks and deformation).

2. Conduct Self-diagnosis using CONSULT-II or "AIR BAG" warning lamp. Refer to "SRS Operation Check" for details. [1][2]Component Tests and General DiagnosticsEnsure entire SRS operates properly.