Diagnostic Procedure 5

Inspecting SRS intermittent malfunction by using CONSULT-II - Diagnosis mode




1. Turn ignition switch OFF.
2. Connect CONSULT-II to Data link connector.




3. Turn ignition switch ON.
4. Touch "START".




5. Touch "AIR BAG".




6. Touch "SELF-DIAG [PAST]".




7. If self-diagnosis result is displayed on "SELF-DIAG [PAST]", go to step 10.




If no malfunction is detected on "SELF-DIAG [PAST]", touch "BACK" and go back to "SELECT DIAG MODE".




8. Touch TROUBLE DIAG RECORD".

NOTE: With "TROUBLE DIAG RECORD", self-diagnosis results previously erased by a reset operation can be displayed.




9. Self-diagnosis result is displayed on "TROUBLE DIAG RECORD".
10. Touch "PRINT".
11. Compare self-diagnosis result to "Intermittent Malfunction Diagnostic Code Chart".
12. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears, then turn off CONSULT-II.
13. Turn ignition switch OFF, then turn off and disconnect CONSULT-II and disconnect both battery cables.

INTERMITTENT MALFUNCTION DIAGNOSTIC CODE CHART (SELF-DIAG [PAST] OR TROUBLE DIAG RECORD):

14. Repair the system as outlined by the Repair order that corresponds to the self-diagnosis result in "Intermittent Malfunction Diagnostic Code Chart". For replacement procedure of component parts, refer to "REMOVAL AND INSTALLATION".
15. Go to "DIAGNOSTIC PROCEDURE 3", Diagnostic Procedure 3for final checking.