Inspection Procedure 2

Inspection Procedure 2: Oil Leaks

DIAGNOSTIC PROCEDURE

STEP 1. Visual check.

Raise the vehicle, and check for oil leaks. If oil leak is difficult to locate, steam clean the transaxle and drive the vehicle for at 10 minutes. Then check the leak again.

Q. Is the oil leak(s) found?

YES Go to Step 2.

NO Check for the oil leaks around the engine. Then go to Step 4.

STEP 2. Visual check at the clutch housing.

Q. Do oil leaks appear around the joint between the engine and the clutch housing?

YES Remove the transaxle. Check the input shaft oil seal, and replace if necessary. Then go to Step 4.

NO Go to Step 3.

STEP 3. Check the oil seal or O-ring for damage.

Q. Is the oil seal or O-ring damaged?

YES Replace the oil seal or the O-ring. Then go to Step 4.

NO Go to Step 4.

STEP 4. Retest the system.

Q. Is the oil still leaking?

YES Return to Step 1.

NO The procedure is complete.