Front Axle

WHEEL BEARING END PLAY CHECK

1. Remove the front caliper assembly and front disk brake, and retain the front caliper assembly with a wire and the like to prevent from falling (Refer to Front Axle Hub Assembly Removal and Installation [Flange Nut Type]).





2. Set a dial gauge as shown in the figure. Move the hub in the axial direction and measure the end play.
Limit: 0.05 mm (0.002 inch)
3. After checking, install the front brake disk and the front caliper assembly (Refer to Front Axle Hub Assembly Removal and Installation [Flange Nut Type]).