Drive Belt (For Water Pump and Generator) (Check Condition)

DRIVE BELT (FOR THE GENERATOR AND POWER STEERING OIL PUMP) (REPLACE)

1. Remove the radiator condenser tank. Service and Repair).





2.
CAUTION:
Check the drive belt tension after turning the crankshaft clockwise one turn or more.

Make sure that the indicator mark on the auto-tensioner is within the area marked with A in the illustration.
3. If the mark is out of the area A, replace the drive belt (Refer to Service and Repair).
NOTE:
The drive belt tension check is not necessary as the auto-tensioner is adopted.

4. Install the radiator condenser tank. Service and Repair).