Removal and Replacement

REMOVAL AND INSTALLATION













REMOVAL SERVICE POINTS

[[A]] REAR BRAKE CALIPER ASSEMBLY REMOVAL

1. Remove the rear brake caliper assembly with the brake hose kept attached.

2. Secure the removed rear brake caliper assembly with a wire or other similar material at a position where it will not interfere with the removal and installation works.

[[B]]REAR BRAKE DISK REMOVAL





If the rear brake disk removal is difficult, install bolts (M8 x 1.25 mm) shown in the figure, and tighten them evenly and gradually to remove the rear brake disk.

INSTALLATION SERVICE POINTS

]]A[[ WASHER INSTALLATION





Install the washer in the direction shown in the illustration.

]]B[[ CHAMBER RETAINER INSTALLATION





Use pliers or a similar tool to close the chamber retainer end onto the pin.

]]C[[ ADJUSTER ASSEMBLY INSTALLATION





Install the adjuster assembly so that the shoe adjusting bolt is positioned at the rear of the vehicle for the left side, and at the front of the vehicle for the right side.

]]D[[ SHOE-TO-ANCHOR SPRING INSTALLATION





The shoe-to-anchor springs are not interchangeable because their spring loads are different.
The one with blue paint must be installed to the vehicle front, and the other with yellow paint to the vehicle rear.