Doors: Service and Repair

REMOVAL AND INSTALLATION

















REMOVAL SERVICE POINTS

[[A]] DOOR BELTLINE MOLDING [FRONT DOOR] REMOVAL





Pry the door beltline molding clip positions with the flat-tipped screwdriver and remove the door beltline molding.

[[B]] DOOR BELTLINE MOLDING [REAR DOOR] REMOVAL

1.




Prize the clip of the door beltline molding using a flat-tipped screwdriver in the order of the numbers (from 1 to 4) shown in the figure. Lift the vehicle front side of the door beltline molding.
NOTE:
The flat-tipped screwdriver cannot be used at clips 5 and 6 of the door beltline molding shown in the figure.





2. Lift the door beltline molding in the direction of the arrow in the figure, then remove the door beltline molding.

[[C]] DOOR OPENING WEATHERSTRIP OUTER REMOVAL





Make the tool as shown in the figure, and remove the weatherstrip from the door panel.

INSTALLATION SERVICE POINTS

]]A[[ DOOR OPENING WEATHERSTRIP OUTER INSTALLATION

The clip color identifies the left and right weatherstrips so be sure to see the colors so as to install correctly.





]]B[[ WATERPROOF FILM INSTALLATION





CAUTION:
When a waterproof film is applied, guide the butyl rubber tape under the inner panel drain hole.

Apply the specified adhesive to the waterproof film as shown in the figure and stick the film.
Butyl rubber tape: 3M(TM) AAD Part number 8633 or equivalent


]]C[[ DOOR WINDOW GLASS RUN CHANNEL INSTALLATION

Apply soapy water to the tip of the door window glass run channel, and then install it to the door.