Inspection Procedure 23

Inspection Procedure 23: No sound. (CD only)

DIAGNOSIS

STEP 1. Check again using another CD, which is not dirty or scratched.

Q. When you substitute another normal CD, is the CD played normally?

YES The original CD is defective. The radio and CD player should sound normally.

NO Go to Step 2.

STEP 2. Check power supply to the radio and CD player when the ignition switch is at "ACC" or "ON" position.

Q. Is the radio and CD player energized when the ignition switch is turned to the "ACC" or "ON" position?

YES Replace the radio and CD player. The radio and CD player should sound normally.

NO Check the memory backup power supply circuit. Refer to Inspection Procedure 1 Inspection Procedure 1.