Inspection Procedure 26

INSPECTION PROCEDURE 26: No Sound (CD Only).

DIAGNOSIS

STEP 1. Check again using another CD, which is not dirty or scratched.

Q. When you substitute another normal CD, is the CD played normally?

YES The original CD is defective. The CD player should sound normally.
NO Go to Step 2.
STEP 2. Check power supply to the CD player when the ignition switch is at "ACC" or "ON" position.

Q. Is the radio and CD player energized when the ignition switch is turned to the "ACC" or "ON" position?

YES Replace the radio and CD player or radio, CD player and CD changer. The CD player should sound normally.
NO Check the memory backup power supply circuit. Refer to Inspection Procedure 1 Inspection Procedure 1.