Overhaul

DISASSEMBLY AND ASSEMBLY

WARNING:
Do not move the tilt lever from the lock position until the installation is completed. If you move it accidentally, the steering column cannot be reinstalled correctly.

CAUTION:
When the ignition key cylinder is replaced, register the encrypted code. Immobilizer System.









DISASSEMBLY SERVICE POINT

[[A]] STEERING LOCK BOLT REMOVAL





1. Drill a hole in the steering lock bolt a hole deep enough for the tap to stand.
2. Remove the steering lock bolt with a left-hand tap.

ASSEMBLY SERVICE POINT

]]A[[ STEERING LOCK CYLINDER ASSEMBLY/STEERING LOCK BOLT INSTALLATION

CAUTION:
The bolts must be replaced with new ones when the steering lock is installed.

1. When installing the engine starting switch assembly to the steering column assembly, temporarily install the engine starting switch assembly in alignment with the column boss.





2. After checking that the lock works properly, tighten the steering lock bolts until the head is twisted off.