Removal and Replacement

REMOVAL AND INSTALLATION













REMOVAL SERVICE POINTS

[[A]] REAR BRAKE BOLT/REAR BRAKE CALIPER ASSEMBLY REMOVAL

Remove the rear brake caliper assembly and support it with wire or something similar.

[[B]] REAR BRAKE DISC REMOVAL





If the rear brake disc is seized, install M8x1.25 bolts as shown, and remove the rear brake disc by tightening the bolts evenly and gradually.

[[C]] REAR BRAKE CHAMBER RETAINER REMOVAL





Use a flat-tipped screwdriver or a similar tool to open up the rear brake chamber retainer joint. Then remove the rear brake chamber retainer.

INSTALLATION SERVICE POINTS

]]A[[ REAR BRAKE CHAMBER RETAINER INSTALLATION





Use pliers or a similar tool to close the rear brake chamber retainer end onto the pin.

]]B[[ REAR BRAKE SHOE SLACK ADJUSTER INSTALLATION









Install the rear brake shoe slack adjuster as shown.

]]C[[ SHOE-TO-ANCHOR SPRING INSTALLATION









CAUTION:
The front and rear shoe-to-anchor springs are not interchangeable, so the blue spring must be installed at the front side and the yellow spring must be installed at the rear side.

Install the shoe-to-anchor springs in the order shown in the illustration.